![]() ![]() These are my best and only debugging tips I have to offer you, I am new to owning a Raspberry Pi and have been lucky in successfully debugging errors like this in the aforementioned six ways. (If you have any software that is out of date on your Pi, this command will update it to the latest versions after you restart your Pi).ģ.) Check for any OS and software updates for your computer(s), if they are security related I strongly suggest you install them. If none of these hardware solutions work for you, then try the following any of these software solutionsġ.) Check for an OS update for the image of Octoprint you have running on your Raspberry Pi 2.Ģ.) If you are running a Linux based operating system on your Pi(Rasbian/Ubuntu), check for any OS and software updates using the command "sudo apt-get update & sudo apt-get upgrade". ![]() I know that all of these solutions sound really basic level and are probably the first things you tried. If the Pi is visible, then try disconnecting it and reconnecting it to your network.ģ.) One last hardware debug to try is connecting to the Pi via Ethernet cable first to the router, and then your computer. Another thing you might want to consider doing is logging into your router via its IPv4 address and checking to see if your Raspberry Pi 2 is visible on your network. With that being said, here are my solutions that are simple and easy to implement.ġ.) Something you might want to try is resetting your router as it could be a clogged network port (like a clogged sink, keep filling it and either the water moves very little or not at all) this tends to happen often if you are running a remote server on a network.Ģ.) Also check if any there are any software updates available for your computer and Pi and read up on weather or not to update. I cannot caution you enough out of experience to not mess with any settings you are unfamiliar with. Most of the errors like this are simple network issues that should be solved by doing the following steps if you see them as applicable to your situation. I have minimal experience with Octoprint, and no experience with Putty. ![]() )Īs for why, I want to go headless with my PI. And I am pretty sure I'm being an a-hole missing something obvious. What settings do I have to check on PuTTY? Things I don't know and possible problems: But I've noticed sometimes it just gets deleted. I've added a blank SSH file as suggested. When I try to connect with PuTTY, I either get a time out, or "Network error: software caused connection abort", or "Network error: connection refused", etc. I can get IP for direct LAN, router LAN and WiFi. I can get the IP addresses through varies means ( Tip: Slic3r does a good job finding IP when setting up connection.). Octoprint works fine through web interface and prints my stuff. My printer can connect to Octoprint (And Repetier server for that matter, but my choice is Octoprint). I have some experience with PuTTY as I use it everyday to work on servers as a web developer. WiFi works, Router LAN works and direct LAN to PC works. I use Octoprint to connect to my printer and everything works fine. ![]() I don't know where else to ask this question, as I've been looking all over the internet for answers. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |